Redmond, WA

House Rewiring in Redmond, WA

House rewiring in Redmond usually comes up during a renovation or when a home needs to support new loads like an EV charger or standby generator. We do whole-home rewires and targeted partial rewires, routing new grounded circuits back to a panel that can handle them.

  • Licensed & insured
  • Family-owned since 1971
  • Permits & inspections handled
  • Free estimates
County
King County
Permits through
City of Redmond Building Department
Power company
Puget Sound Energy (PSE)

House Rewiring for Redmond homes

In Redmond, a lot of our electrical work involves renovations, panel upgrades, EV chargers, and generators, often in the same home. When walls are open for a kitchen or bath remodel in Education Hill or Grass Lawn, it's the right time to replace old branch circuits rather than add new loads onto them. Homes from the 1960s–70s may also have solid-aluminum branch circuits, and any home with ungrounded wiring won't support the GFCI and AFCI protection that modern kitchens, baths, and living areas need.

Rewiring requires an electrical permit, which we pull through the City of Redmond Building Department, scheduling both rough and final inspections. We run new NM cable, land it in a modern, properly labeled panel, and correctly abandon old wiring instead of leaving it energized in the walls. If your panel is full or too small for the new circuits, we may recommend a 200-amp, 40-space Square D QO panel or a subpanel, coordinating any service-side work with Puget Sound Energy (PSE).

We begin by checking the attic, crawlspace or basement, and a few device boxes to see what's in your walls. Then we recommend either a full rewire or a phased plan, prioritizing the highest-risk circuits first and timing the work around your renovation if you have one underway. We plan routing to minimize drywall cuts. Call All City Electric at (206) 533-6333 to schedule an assessment.

House Rewiring in Redmond: common questions

Should I rewire during my Redmond kitchen or bath remodel?

It's often the best time. With walls open, we can replace the kitchen and bath circuits with grounded, GFCI/AFCI-protected wiring for far less disruption than doing it later. A targeted partial rewire of these rooms is one of our most common jobs.

Who issues rewiring permits in Redmond?

Electrical permits in Redmond come from the City of Redmond Building Department. We pull the permit, schedule the rough and final inspections, and make sure the new circuits are grounded and protected to code.

Will rewiring my home require a panel upgrade?

Sometimes. If your panel is full, ungrounded, or too small for the new circuits, especially if you're also adding an EV charger or generator, we'll recommend a panel upgrade or subpanel and coordinate any service work with PSE.

Can a rewire be done in stages?

Often, yes. We can prioritize the highest-risk circuits, such as aluminum branch circuits or kitchen and bath loads, and phase the rest over time. We'll map what you have and suggest a sequence that fits your plans.

Reviews

What our neighbors say

Most of our work comes from repeat customers and referrals across Seattle and the north end.

I called All City Electric when my laundry room and living room lights would not turn off. If you tried to turn them off they flicker. Then 5 of my outlets either didn't work or things would fall out of them. … The gal that answered my call was very sweet and kind. Today, Kevin showed up on time and confirmed the problem and got to work right away. He was pleasant and kind during the entire process. He answered all my questions. … You will forever have my business.
JJeniLighting & outlet repair

Need house rewiring in Redmond?

Free quotes from a licensed, family-owned electrician serving the Seattle area since 1971.